Módulo de sensor de temperatura Arduino Keyes KY-001, permite la medición de la temperatura ambiente utilizando el bus serie digital.
KY-001 ESPECIFICACIONES
El módulo de sensor de temperatura KY-001 consta de un sensor de temperatura digital de bus único DS18B20, un LED y una resistencia. Compatible con plataformas de electrónica populares como Arduino, Raspberry Pi y Esp8266.
Diagrama de conexión
Conecte la línea de alimentación (medio) y tierra (-) a +5 y GND, respectivamente. Conecte la señal (S) al pin 2 en el Arduino.
Código de ejemplo
El siguiente boceto de Arduino utilizará la biblioteca OneWire para comunicarse en serie con KY-001 y generará la temperatura leída por el dispositivo.
Los enlaces a las bibliotecas requeridas para el boceto de ejemplo KY-001 Arduino se pueden encontrar en la sección de Descargas a continuación.
#include #include // Data wire is plugged into pin 2 on the Arduino #define ONE_WIRE_BUS 2 // Setup a oneWire instance to communicate with any OneWire devices (not just Maxim/Dallas temperature ICs) OneWire oneWire(ONE_WIRE_BUS); // Pass our oneWire reference to Dallas Temperature. DallasTemperature sensors(&oneWire); void setup(void) { // start serial port Serial.begin(9600); Serial.println("Dallas Temperature IC Control Library Demo"); // Start up the library sensors.begin(); // IC Default 9 bit. If you have troubles consider upping it 12. Ups the delay giving the IC more time to process the temperature measurement } void loop(void) { // call sensors.requestTemperatures() to issue a global temperature // request to all devices on the bus Serial.print("Requesting temperatures..."); sensors.requestTemperatures(); // Send the command to get temperatures Serial.println("DONE"); Serial.print("Temperature for Device 1 is: "); Serial.print(sensors.getTempCByIndex(0)); // Why "byIndex"? You can have more than one IC on the same bus. 0 refers to the first IC on the wire }